Ph24-R - Monessen Hearth PH18 Installation And Operating Instructions Manual

LOG PLACEMENT
The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and firmly positioned in the appliance.
Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to
the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically
approved for this heater may result in property damage or personal injury.
PLACE PH24-R LOGS
1. Place Rear Log (#1) on rear support. Figure 21
2. Place Left Middle Log (#2) on middle support and
burner. Figure 22
3. Place Right Middle Log (#3) on middle support.
Figure 22
NOTE: Logs #1, #2 and #3 have ridges on the bottom
which secure the logs to burner frame. After installing
each log, check to be sure it is stable.
Left Middle Log #2
Figure 22
Monessen • PH18/24 Installation/Owner's Manual • 65D2035 • Rev G • 03/2020
Figure 21
Right Middle Log #3
LG1089
PH24 logs 2 3
Rear Log #1
D O N O T s p r i n k l e
LG1088
volcanic rock on the
PH24 log 1
logs or around the pilot
or the main burner. This
may cause sooting.
Only place volcanic
rock on the floor of the
fireplace.
During initial operation
o f t h e n e w h e a t e r,
burning logs will give off
a paper burning smell
and orange flames will
be present. Simply open
the windows for a few
hours to vent the odor.
LG1089
PH Gas Logs
LG1088
19