1. Manuals
  2. Brands
  3. Makita Manuals
  4. Nail Gun
  5. AN510H
  6. Instruction manual

Makita AN510H Instruction Manual

Construction nailer
Hide thumbs Also See for AN510H:
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUAL
Construction Nailer
AN510H
009358
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1

Advertisement

Table of Contents
loading

Related Manuals for Makita AN510H

Summary of Contents for Makita AN510H

  • Page 1 INSTRUCTION MANUAL Construction Nailer AN510H 009358 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    2 “x 4” housing. EC Declaration of Conformity ENG102-3 Makita Corporation responsible Noise manufacturer declare that the following Makita The typical A-weighted noise level determined according machine(s): to EN792: Designation of Machine: Sound pressure level (L ) : 83 dB(A)

  • Page 3: Important Safety Instructions

    Tomoyasu Kato be buttoned or rolled up. No necktie should be Director worn. Makita Corporation Rushing the job or forcing the tool is dangerous. • 3-11-8, Sumiyoshi-cho, Handle the tool carefully. Do not operate when Anjo, Aichi, JAPAN under the influence of alcohol, drugs or the like.
  • Page 4 − closing boxes or crates; Makita. − fitting transportation safety systems e.g. on Ask Makita's Authorized service centers for • vehicles and wagons. periodical inspection of the tool. Do not permit those uninstructed to use the tool. To maintain product SAFETY and RELIABILITY, •...

  • Page 5: Installation

    Use an air hose as large and as short as possible to SAVE THESE INSTRUCTIONS. assure continuous, efficient nailing operation. CAUTION: INSTALLATION Low air output of the compressor, or a long or • smaller diameter air hose in relation to the nailing Selecting compressor frequency may cause a decrease in the driving capability of the tool.
  • Page 6 1. Adjuster 1. Protrusion 2. Shallow 2. Protrusion 3. Deep 3. Nose adapter 009366 009368 Attach the board adapter for plaster board and other 1. Too deep siding boards, and the floor adapter for flooring. The 2. Flush board adapter is attached to the contact arm cover when 3.

  • Page 7: Loading The Nailer

    ASSEMBLY 1. Door 2. Nail guide 3. Feeder CAUTION: Always disconnect the air hose before loading the • nailer. Loading the nailer CAUTION: 009363 Make sure that the coil support plate is set to the • correct step for used nails. Connecting air hose 1.
  • Page 8 CAUTION: CAUTION: However when the tool is set to the "Intermittent Always disconnect the hose before cutting off the • • Nailing" mode, WITH THE TRIGGER HELD IN A sheet. HALF-PULLED POSITION, an unexpected nailing Tear off the output sheet in the direction of the arrow could occur, if contact element is allowed to when using the sheet collated nails.
  • Page 9 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. 004318 Nails • Air hoses • After operation, always drain the compressor tank and Safety goggles •...
  • Page 12 Makita Corporation Anjo, Aichi, Japan 884843B222...

Table of Contents