Front And Rear Panel Illustration - VIORE PLC7V96 Operating Instructions Manual

Front and Rear panel illustration

1. Front View
16
1) Antenna input: Connect to an external RF signal.
2) Speaker Left: The left speaker.
3) VOL+: Move around the menu screens or changing the volume in non-menu state.
4) CH+: Move around the menu screens or selecting the channels in non-menu state.
5) VOL-: Move around the menu screens or changing the volume in non-menu state.
6) OK: Confirm a selection within a menu.
7) CH-: Move around the menu screens or selecting the channels in non-menu state.
8) ASPECT: To change picture aspect.
9) MENU:Open the main menu window.
10) EXIT: Exit menu.
11) Speaker Right: The right speaker.
12) REMOTE CONTROL SENSOR: Receive the signal from the remote control
13) STANDBY:To set the portable TV to standby.
14) SOURCE: To select input source.
15) TFT screen: Display the TFT widescreen display.
16) External rod Antenna
2. Right View
CHARGE
DC IN 12V
1 2
1) CHARGE INDICATOR: The system is in charging state when red LED is lighting,
it will turn into green when full charged.
2) DC IN JACK: This is used for AC-DC adaptor input, the voltage range is 12V .
3) POWER SWITCH: This switch used to switch on/off the system, the system will enter fast
charging state if the DC adaptor connected in power off state.
4) EARPHONE JACK: This jack outputs analog audio L/R signal to earphone.
5) DIGITAL AUDIO OUT: This jack outputs analog coaxial audio signal.
6) AUDIO IN JACK: This jack is used for input analog audio L/R signal to system.
7) VIDEO IN JACK: This jack is used for input composite video signal to system.
8) AUDIO OUT JACK: This jack out puts analog audio L/R signal.
AUDIO IN JACK and VIDEO IN JACK should be used at the same time.
AUDIO IN cannot be used for audio-only without an associated video connection
1
2
3
4
CH+
5
V- OK V+
6
CH-
7
ASPECT MENU
8
9
10
DIGITAL
OFF ON
AUDIO IN VIDEO IN AUDIO OUT
AUDIO OUT
3 4 5 6 7 8
9
11
12
STANDBY
13
SOURCE
14
15