Removing the bezel (Model 225)
Figure 16. Removing the bezel of the Model 225
To remove the bezel:
1. Move the blue bezel-release lever, following the curve of the lever opening.
2. Lift the bezel tabs out of the slots and pull the bezel away from the appliance
Installing internal drives
You can install a tape drive to store more data. You can see a list of supported tape
drives at www.storage.ibm.com.
Installing internal drive bays
Internal hard drives are installed in bays. The drive bays of the Network Attached
Storage 200 are in the front of the appliance, as shown in the following illustrations.
Attention:
drive bays, you must install the power supply backplane option and additional
power supplies.
front. Store the bezel in a safe place.
If you are going to install additional hard drives in the non-hot-swap
Bezel-release lever
Bezel
Chapter 4. Adding and replacing components
55