Connection And Start-Up - Camsat CDS-LIFT IP User Manual

Connection and start-up

It is recommended that the first start-up and configuration of the system is made on the
desk at small distances. This can save a lot of valuable time with the configuration of
many different cameras.
Transmitter (IP camera side):
Set dipswitch 1 to OFF mode (transmitter), set the operating channel according to
•
the table, set the number of transmitter (if there is more than one transmitter).
connect IP camera with a network cable with RJ45 PORT-2
•
connect included power supply PoE48V to PORT-1
•
connect the second camera by the network cable to the RJ45 LAN input in the
•
power supply of the transmitter.