Preparation For Operation - Camsat CDS-LIFT IP User Manual

DESCRIPTION OF CONNECTORS AND LED INDICATORS
RESET - reset button for the radio module to the default settings
PORT 2 - LAN port for connecting a second IP camera
PORT 1 - LAN port for connection to the DVR or connect the power adapter PoE48V.
This port can also be used to connect a second IP camera through the LAN in the
power supply.
SETTINGS – switches used to configure the device
LINK – LED indicator of the connection:
red - the signal is too strong (overdrive), or device is starting;
orange - a link with a high signal level (very good signal);
green - a valid link with the correct signal level;
off - the device is out of range or is incorrectly configured. More information about the
level of radio signals can be obtained by logging on to the users' panel website.
POWER – red

Preparation for operation

It is recommended that the first start-up and configura-
tion of the system is made on the desk at small dis-
tances. This can save a lot of valuable time with the
configuration of many different cameras on the ob-
ject.
Function
Operating mode:
Operating channel
and IP address of the
device:
In parentheses you can see the IP address of the device that depends on the settings. The
receiver always has the address of the ID 192.168.x.1. These addresses are reserved for radio
equipment.
LED for power status
SETTINGS
Receiver
Transmitter
CH 36 (CE FCC) 5.180 Ghz
CH 40 (CE FCC) 5.200 Ghz
CH 44 (CE FCC) 5.220 Ghz
CH 48 (CE FCC) 5.240 Ghz
CH 149 (FCC) 5.745 Ghz
CH 153 (FCC) 5.765 Ghz
CH 157 (FCC) 5.785 Ghz
(192.168.112.x)
(192.168.113.x)
(192.168.114.x)
(192.168.115.x)
(192.168.116.x)
(192.168.117.x)
(192.168.118.x)