Erase All Bluetooth Pairings; Cisco Headset 560 Series Conferencing - Cisco Headset 500 Series User Manual

Erase All Bluetooth Pairings

Erase All Bluetooth Pairings

You can erase all saved Bluetooth device pairings.
Procedure
Press and hold the Bluetooth button on the back of the multibase for four seconds to clear the memory.

Cisco Headset 560 Series Conferencing

If your administrator has enabled headset conferencing, you can pair up to three guest Cisco Headset 560
Series headsets to either the standard base or the multibase. With this feature, people that sit near you can
connect to each other and to the same call with one base. You can conference headsets both on and off an
active call. If the call source or the multibase is muted, conferenced headsets can interact with each other and
won't interfere with the active call.
If you are on a call and need a coworker to join the call, the coworker's headset can pair with your base. When
the call ends, you and your coworker are still connected to each other. Decide on a base that will act as the
primary base and pair your coworker's headsets to that base. When you no longer need people connected to
your base, they can pair their headsets back to their own bases.
Headset Firmware Release 1.5(1) or later is required for a headset to enter conferencing mode.
Headset Firmware Release 2.1(1) or later enables headset conferencing capabilities by default.
When the base is in conferencing mode, the battery status LEDs display number of connected headsets and
each headset's status. The far-right LED shows the primary headset status while the middle LEDs indicate
the status of each guest headset. The LEDs light in order as headsets connect. When a headset disconnects,
newer headsets keep their position on the base. The following figure and table show the corresponding
conference mode LEDs.
Cisco Headset 500 Series User Guide
12
Your Headset