Cisco Aironet 1400 Series Manual page 24

4. Position the non-root bridge's antenna to the azimuth, elevation, and
polarization recommended by the site survey. If the site survey data is
correct, the two antennas are pointed towards each other close to the
line-of-site signal path.
5. Power up the non-root bridge.
6. Observe the non-root bridge LEDs and confirm that the bridge has
associated to the root bridge. (Install LED is continuous amber.)
7. Pan the bridge's antenna from side to side and tilt it up and down while
observing the RSSI LEDs. The goal is to obtain as many continuous
amber LEDs as possible.
8. Optional—Fine tune the alignment using a voltmeter.
9. Secure the non-root bridge mounting fasteners.
10. Return to the root bridge location.
11. Observe the root bridge LEDs and confirm that the bridge is associated
with the non-root bridge. (Install LED is green.)
12. Repeat Steps 7 and 8.
13. Secure the root bridge mounting fasteners.
The bridges are ready to be configured and incorporated into your network.
24