Panasonic KX-TGB610E Operating Instructions Manual page 29

Problem
The unit does not work.
The handset display is
blank.
I cannot hear a dial tone.
I cannot use the intercom
feature.
Menu list
Problem
The display is in a
language I cannot read.
I cannot register a handset
to a base unit.
I cannot remember the
PIN.
Battery recharge
Problem
The handset beeps and/or
flashes.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Cause/solution
R Make sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 11).
R Check the connections (page 10).
R Unplug the base unit's AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
R The handset has not been registered to the base unit. Register
the handset (page 31).
R The handset is not turned on. Turn the power on (page 13).
R Make sure that you are using the supplied telephone line cord.
Your old telephone line cord may have a different wiring
configuration.
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working
telephone operates properly, contact our service personnel to
have the unit repaired. If the working telephone does not
operate properly, contact your phone service provider.
R This feature is available between the handsets. Although the
handset displays "Intercom", this feature is not available for
single handset models.
Cause/solution
R Change the display language (page 13).
R You entered the wrong PIN. If you forget your PIN, see "I
cannot remember the PIN." (page 29).
R Change the PIN using the following method.
1
M N#132
2
*7000
3
Enter the new 4-digit base unit PIN. a M
4
MeN
Cause/solution
R Battery charge is low. Fully charge the batteries (page 11).
Useful Information
N 2 times
29