Table of Contents
Advertisement
Next, begin removing the rest of the screws holding the mainboard to the bottom half of the plastic case.
Keep in mind that when reassembling your console that the screws go back in a certain method as some
are left blank for the steel chassis to mount though.
Once you have the board out of the console, flip it over to show the bottom layer of the PCB (as seen in the
image below). Next, carefully peel off the double-sided tape on the back of the Switch Board, and adhere it
to the seen location marked in red below. Do not place it anywhere besides the specified area, and ensure
that you have the Switch Board orientated in the correct position before securing it. Ensure the Switch
Board is adhered well and it will not fall off and short itself against the steel/metal chassis that is housed
under the PlayStation mainboard.
4
PSIOSB08052016-PU7
Advertisement
Table of Contents
