O.S. engine Max-37SZ-Hring Owner's Instruction Manual page 10

Graduations on the carburetor body
Fully opened position
Approx.
As shown in the sketch, the carburetor has
graduation marks. When the triangle mark on the
carburetor rotor meets the most right mark, throttle is
fully closed. When the triangle mark meets the top
mark, throttle is fully open. The range is approximately
80 degrees. You may use other three marks as the
reference marking of throttle opening to your
preference when hovering.
WARNING!
Never try to check the triangle mark position
while the engine is running and rotor is
rotating, or you may be hit by rotating rotor which
results in serious injury. Stop the engine and
rotor before checking the triangle mark position.
4. Checking the rotating direction of the starter
Make sure that the starter rotates
to the direction shown in the
sketch. If the direction is reverse,
reverse the leads on battery.
Inserting the starter shaft
5.
Insert the starting shaft into the
shaft cup securely.
Priming
6.
Without heating the glowplug, open
the throttle a little from the idle
position. Turn the engine using the
starter until the fuel is seen to reach
carburetor.
7.
Preparation of starting
Make sure that the transmitter
throttle stick is at the fully closed
position and the throttle trim at
center position, and make sure that
idle-up switch on the transmitter is
off. Hold the rotor head by hand so
that rotor cannot rotate when the
engine is Started. Also, steady the
model with a foot on the landing-
gear skid.
Fully closed position
Carburetor Body
Carburetor Rotor
18
19
STARTING
Be sure to use a muffler pressurized fuel feed. Use
the same fuel as you intend to employ for actual
operation of your model.
1. Opening and closing of the Needle-Valve
Turn the needle clockwise to
close the needle-valve, and turn
the needle counter-clockwise to
open the needle-valve as shown
in the sketch.
2. Opening the needle-valve
Firstly, turn the needle clockwise slowly until it
stops. The position it stops is the fully closed
position of the needle-valve. Make note this
position for reference..
Open the needle-valve 1.5 turns.
3. Preparation of the starter
Install the starting shaft to the
starter securely. Poor installation
swings the starting shaft, which is
dangerous.
8. Starting
Connect the battery to the glowplug and start the
engine by applying the starter. When started,
switch off the starter and withdraw the starting
shaft after making sure the rotation of the starter
shaft stops.
Stopping the engine
9.
Fully pull down the throttle trim on the transmitter.
Note:
Make sure that the throttle linkage is
made so that the throttle is fully closed
when the throttle lever as well as trim
lever on the transmitter are fully pulled
down.
In case the engine does not stop.
Hold the rotor head, and pinch the silicone tube to
stop the fuel supply. If it still does not stop, pull off the
fuel tubing from the carburetor.
It is necessary to readjust the throttle linkage so that
the carburetor rotor is fully closed when the throttle
stick and throttle trim on the transmitter are fully
pulled down.
Close
Open