Toro Reelmaster 3555 Operator's Manual page 18

Tilt-Steering Lever
Pull the tilt-steering lever
steering wheel to the desired position. Then push the
lever forward to secure the position.
Ignition Switch
The ignition switch (Figure
and preheat the engine, has 3 positions: O
O /P , and S
N REHEAT TART
O /P position until the glow-plug indicator
N REHEAT
light goes out (approximately 7 seconds); then rotate
the key to the S position to engage the starter
TART
motor. Release the key when the engine starts. The
key moves automatically to the O
shut off the engine, rotate the key to the O
Remove the key from the switch to prevent accidental
starting.
Figure 23
1. Parking brake
2. Ignition switch
3. Enable/Disable switch
4. Diagnostic light
5. Lower mow/raise control
lever
6. Hour meter
Throttle
Move the throttle (Figure
engine speed and rearward to decrease the engine
speed.
Enable/Disable Switch
Use the enable/disable switch
conjunction with the lower mow/raise control lever to
operate the cutting units. The cutting units cannot
be lowered when the mow/transport lever is in the
transport position.
(Figure 21) back to tilt the
23), used to start, stop,
,
FF
. Rotate the key to the
/R position. To
N UN
position.
FF
7. Oil-pressure light
8. Temperature light
9. Light switch
10. Glow-plug indicator light
11. Throttle
12. Alternator light
23) forward to increase the
(Figure 23) in
Hour Meter
The hour meter
machine operation. The hour meter starts to function
whenever the key switch is in the O
Lower Mow/Raise Control Lever
This lever (Figure
units and also starts and stops the cutterheads
when the cutterheads are enabled in the mow mode.
The cutting units cannot be lowered when the
mow/transport lever is in the transport position.
Note:
When the cutting units are enabled, the lever
does not have to be held in the forward position while
the cutting units are lowered or raised.
Engine Coolant Temperature
Warning Light
The temperature warning light
the engine coolant temperature is high. The cutting
units will be disabled. If the coolant temperature rises
another 5.5° C (10° F), the engine will be shut off to
prevent further damage.
Oil-Pressure Warning Light
The oil-pressure warning light
engine-oil pressure drops below a safe level.
g019980
Alternator Light
The alternator light
the engine is running. If it is on, the charging system
should be checked and repaired as necessary.
Glow-Plug Indicator
The glow-plug indicator light
the glow plugs are operating.
Parking Brake
Whenever the engine is shut off, engage the parking
brake (Figure 23) to prevent accidental movement of
the machine. To engage the parking brake, pull up on
the lever. The engine stops if you press the traction
pedal with the parking brake engaged.
Diagnostic Light
The diagnostic light
system fault occurs.
18
(Figure 23) indicates the total hours of
position.
N
23) raises and lowers the cutting
(Figure
(Figure 23) glows if the
(Figure 23) should be off when
(Figure 23) glows when
(Figure 23) illuminates when a
23) glows if