Korg DW-8000 Owner's Manual page 45

IZ) When the OISPLA Y again shows TAPE, then you can
stop the tape recorder.
This completes the SAVE procedure. However, it is
good practice to repeal the SAVE procedure several
times, as a hedge against the possibility of losing
data because of tape dropouts.
~
Reset the DW-8000 rear panel TAPE switch to the
DISABLE position.
*
Do not change any settings on the DW-8000 until you
complete the VERIFY procedure (in the following
section).
■
If you listen to a tape of recorded data, you will
hear the following tones:
Level set tone (lower pitched "oooh ")
Leader tone (h1gh-p1tched "eee ")
J
Data tone (med1um-p1 tched "noise")
End tone (h1gh-p1tched "eee ")
J
Level set tone (lower pitched "oooh")
TAPE INTERFACE
E
•
PllOGRAM NO PARAMETER NO
TAPE
ENABlE DISABLE
7
r
(]ii
-
Leader tone: indicates the start of VERIFY and LOAD
operations.
Data tone: Th.e actual digital data from OW-8000 sound
program memory.
End tone: inclicates ihe end of the operation.
45