Checking The Signal Strength; Installing The Home Connect Software Update; Resetting Home Connect Set- Tings - Siemens K IS H Series User Manual

en Home Connect
If the temperature display (freezer
6.
compartment) shows
Home Connect settings.
→ "Resetting Home Connect set-
tings", Page 24

Checking the signal strength

You should check the signal strength
if no connection could be estab-
lished.
Press .
1.
a The temperature display (refriger-
ator compartment) shows
Press / (Refrigerator compart-
2.
ment) repeatedly until the temper-
ature display (refrigerator compart-
ment) shows .
a The temperature display (freezer
compartment) shows a value
between (no reception) and
reception).
Note: The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
Carry out one of the solution op-
▶
tions:
Place the router and refrigerator
‒
closer together.
Ensure that the connection is
‒
not interfered with by screening
walls.
Install a repeater to strengthen
‒
the signal.
24
, reset the
.
a The temperature display (refriger-
(full
a The temperature display (freezer
a The update is installed.
a The controls are locked during the
a If the installation is successful, the
Installing the Home Connect
software update
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note: If updates are available, the
temperature display (refrigerator
compartment) shows
To reset the update and the temper-
ature display (refrigerator compart-
ment) to the set temperature, press
any touch field.
Press .
1.
ator compartment) shows
Press / (Refrigerator compart-
2.
ment) repeatedly until the temper-
ature display (refrigerator compart-
ment) shows
ure display (freezer compartment)
shows .
Press / (Freezer compartment).
3.
compartment) shows an animation.
installation.
temperature display (freezer com-
partment) shows
If the temperature indicator (freezer
4.
compartment) shows
ance was unable to install the up-
date.
Repeat the process at a later
‒
point.
If the update cannot be completed
5.
after several attempts, contact the
After-sales service → Page 37.
Resetting Home Connect set-
tings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
.
.
and the temperat-
.
, the appli-