Advertisement
SCION
Procedure
10 mm Socket, Ratchet, Extension, Side Cutter
Ground Cable
Front
Lock Tie A x1
Fig. 6-1
Masking Tape
Template
Template
Roof
Fig. 7-1
Align with the
Protective Paper
front edge
Double-Sided
Adhesive Tape
Fig. 7-2
Issue: A 02/28/07
xB
2008 -
Ground Point
Tuner Cable
Clamps x3
Front
Template
Ditch
Molding
Roof
Front
Antenna
Page 10 of 21 pages
XM SATELLITE RADIO
6. Route the Tuner Ground Cable
(a) Install the end of the tuner ground cable onto
the bolt located on the cowl side. (Fig. 6-1)
(b) Secure the tuner ground cable and tuner cable
using the vehicle wire harness clamps.
(c) Secure the tuner ground cable and tuner cable
to the vehicle wire harness using a lock tie A
as shown. (Fig. 6-1)
(d) Use a side cutter to cut off the excess lock tie
length.
7. Install the Antenna
(a) Clean the template (template B) mounting
TM
area with 3M
method. (Fig. 7-1)
(b) When cleaning with 3M
and cleaning method,
(1) Always use a clean (lint free scratch
STOP
resistant) soft cloth (or wipe), and clean a
small area at a time (~ 3 ft. x 3 ft. max.).
(2) Shake well.
TM
(3) Apply 3M
STOP
wipe. Do not spray cleaning solution
directly on any vehicle surfaces.
(4) Clean surface thoroughly and wipe dry
immediately with a new clean cloth. Do
not allow cleaner to air dry.
(c) Position antenna template on the near right
corner of the roof as shown. Secure the
template with masking tape. (Fig. 7-1)
(d) Remove the release paper from the back of
antenna, and then affix the antenna onto the
roof. (Fig. 7-2)
(1) Align the front edge of the antenna with
the template as shown and install it
carefully.
(2) Once attached, the antenna cannot be
STOP
easily removed.
Prep Solvent 70 and cleaning
TM
Prep Solvent 70
Prep Solvent 70 to cloth or
DIO
Advertisement
