Warnings; Assembly And Hookup Information - Mr. Heater MH45T Operating Instructions And Owner's Manual

asseMBlY and HOOK-uP InFOrMaTIOn
1. Heater model MH45t is packaged complete. Propane
cylinders (tanks) are not included with heater model.
2. Remove heater from carton.
3. use only vapor withdrawal lP gas cylinders constructed
for use with propane only (HD-5) and marked in accor-
dance with the specifications for lP gas cylinders of the
U.S. Department of Transportation (DOT SPEC. 39).
4. this heater must be used only with a vapor withdrawal
LP gas bulk tank equipped with a standard POL valve.
5. MH45T Triple Burner Model (see Figure 1.)
• The tank collar bracket must be assembled before
the heater can be attached to the propane tank.
• Remove screws from manifold center plate and
retain for later use.
• Align bolt holes in tank collar bracket with bolt
holes in center plate on manifold such that the
heater is facing outward once attached to cylinder
collar.
• Attached with screws removed above, to manifold
center plate.
• Place heater onto tank with tank collar bracket over
tank collar. Mounting bolt knob should be posi-
tioned to the outside of tank collar.
• Firmly secure to tank by hand-tightening mounting
bolt knob. Do not overtighten.
• Make sure heater regulator is in the "OFF" position.
• Insert regulator's connector into tank's valve and
turn left (counterclock-wise) with hand as much as
possible. Do not overtighten.
6. operate only on a stable, level surface.
7. open propane tank valve slowly.
8. Check all fittings for leaks. Apply a 50/50 mixture of
liquid soap and water to all joints. Bubbles forming
indicate a leaking connection. Correct all leaks before
proceeding.
Warning
never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
9. the heater should be inspected before each use and at
least annually by a qualified service person.
10. the hose assembly shall be visually inspected prior to
use of heater. If it is evident there is excessive abrasion
or wear, or the hose is cut, it must be replaced prior to
the heater being put into operation. Replacement hose
assembly shall be Mr. Heater hose assembly as listed in
the parts list.
11. Minimum inlet gas pressure is 20 psi (138 kPa).
12. Maximum inlet gas pressure is 120 psi (827 kPA (equiva-
lent to an ambient temperature of 75°F (24°C)).
Mr. Heater | Gas-Fired Infra-Red Tank Top Heater e-3 Operating Instructions and Owner's Manual
Figure 1.