Adjusting The Spray; Auto Stop System - IVT HPC-1400 Manual

Operating instruction

Adjusting the spray

The nozzle is adjustable to allow you to adjust the spray from a
tight jet of water to a wide spray.
To adjust the nozzle, proceed as follows:
1. Hold the shaft of the lance in one hand.
2. Twist the nozzle with the other hand.
3. The tight jet should be used to clean small areas where a
small spray is required.
4. The wide spray should be used for cleaning large (and
sensitive) areas.

Auto stop system

The pressure washer is fitted with a automatic stop system to
protect the motor when in use.
• When the switch lever (16) is released the motor will stop.
• When the the switch lever (16) is squeezed the motor will
start up again.
Fitting the detergent spray attachment
WARNING
Before using the detergent spray attachment make sure that
there are no other people or domestic animals in the work
area.
WARNING
Before starting any cleaning, or maintenance procedures on
the washer, ensure that is disconnected from the mains power
supply.
(HPC-1400)
To fit the detergent spray attachment, proceed as follows:
1. Make sure that the handgun (11) is locked in the
position.
2. Fill the detergent tank (8) with a suitable biodegradeable
detergent. [F8]
3. Fit the detergent sprayer (7) to the tank (8) by inserting the
detergent delivery tube into the tank and screwing the nozzle
on to the head of the tank.
4. Connect the detergent sprayer to the handgun (11).
5. Release the lock-off button (12) and point the nozzle at the
area to be sprayed.
6. Squeeze the the switch lever (16).
7. Proceed with the wash.
(HPC-2000)
To spraying detergent, proceed as follows:
1. Make sure that the handgun (11) is locked in the
position.
2. Pull the cap of detergent tank (8).
3. Pull up the regulating sleeve of the lance (10).
4. Put the detergent into the tank and push down the cap.
5. Release the lock-off button (12) and point the nozzle at the
area to be sprayed.
6. Squeeze the the switch lever (16).
7. Proceed with the wash.
(HPC-2400)
To spraying detergent, proceed as follows:
1. Make sure that the handgun (11) is locked in the
position.
2. Pull out the detergent tank (8) cover.
[F7]
3. Fill the tank with a suitable biodegradeable detergent.
4. Release the lock-off button (12) and point the nozzle at the
area to be washed.
5. Squeeze the switch lever (16).
6. Pull forward the adjusting sleeve of the lance (10) up.
7. Proceed with the wash.
[F13]
This appliance has been designed for use with the cleaning
agents recommended by the manufacturer. The use of other
cleaning agents or chemicals may adversely affect safety and
durability of the appliance.
The use of the folding transport handle
(HPC-2000; HPC-2400)
The models HPC-2000 and HPC-2400 are equipped with a
folding transport handle (1) used for moving the machine. Before
moving the device it must be switched «Off» and protected
against unintentional start. To move the device upstairs or over
obstacles, lift it by the handle.
• Pull out the folding transport handle when you want to
move the machine.
• Push in the folding transport handle after use it.
The use of the winding high pressure hose device
(HPC-2400)
«Off»
The winding high pressure hose device (15) can be moved using
the handle provided.
• To increase the length of the hose rotate the handle
clockwise.
• To shorten the length of the hose rotate the handle
counterclockwise. [F14]
[F9]
Using the washer
We recommended that washing procedure should be performed
in two stages:
• Dirt dissolution:
shaped jet stream and wait for a moment until the fluid begins
working.
• Dirt removal:
«Off»
• While cleaning, make sure that the washer is positioned on
an even base.
• You should not move outside the work area limited by the
[F10]
length of the high pressure hose, as you may upset the washer's
balance.
• While washing vertical surface, apply the washing fluid
17
Instruction manual
[F11]
[F12]
CAUTION
introduce the washing fluid into a fan
wash the dirt off with a point jet stream.
EN
«Off»