Table of Contents
Advertisement
3
3
Slot
Bars
Back View
Back View
• Place the dungeon base on a flat surface with the
back facing you.
• At an angle, insert one of the pegs on the bars into
one of the holes in the dungeon base, as shown.
Insert and snap the other peg on the bars into the
other hole in the dungeon base.
• Insert the tab on the drawbridge assembly into the
slot in the dungeon base.
• At an angle insert one of the pegs on the door into
one of the holes in the dungeon base, as shown.
Insert and snap the other peg on the door into the
other hole in the dungeon base.
A
s
s
e
A
s
s
e
Drawbridge
Assembly
Tab
Dungeon
Base
Door
m
b
l
y
m
b
l
y
4
4
Drawbridge
Assembly
Bottom View
Bottom View
• Tip the assembly face down.
• Insert three screws through the bottom of the
dungeon base and into the drawbridge assembly.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
5
5
Drawbridge
Assembly
Dungeon Base
• Turn the assembly upright.
• Position the large turret so that the back faces
you. Insert and snap the large turret tabs into
the dungeon base slots.
4
Dungeon
Base
Large Turret
Back View
Back View
Tabs
Advertisement
Table of Contents
