Checking Before The Setup; Switching The Connection Method To Wireless Lan; Checking The Wireless Router - Canon Color imageCLASS MF8580Cdw Settings Manual

Checking Before the Setup

Internet
Is the computer connected to the wireless router
correctly by a LAN cable or wireless LAN?
For more information, see the instruction manual for the
network device you are using, or contact the networking
device manufacturer .
Has the network settings on the computer been
completed?
If the computer is not properly configured, you may not use
the wireless LAN connection even after completing the
following settings .
NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time . In addition, the machine is set
to the "Wired LAN" by default .
• When you connect to a network environment that
is not security protected, your personal information
could be disclosed to third parties . Please use
caution .
• If you connect through a LAN in the office, contact
your network administrator .
• In this manual, a wireless device that is accessed
from satellite terminals is generally called as
"wireless router ." The term "access point" means
a master terminal on a wireless LAN that satellite
terminals access to .
• When proceeding from "Connecting the Power
Cord and Turning ON the Power" in the Getting
Started:
Proceed to "Checking the Wireless Router" on the right
side of this page .
Switching the Connection Method to
Wireless LAN
En
1
Press .
2
Select <Network Settings>, and then press [OK] .
3
Select <Select Wired/Wireless LAN>, and then
press [OK] .
4
Wireless Router
4
Select <Wireless LAN>, and then press [OK] .

Checking the Wireless Router

Select the connection method to the wireless LAN . Select
from the following two methods depending on the wireless
router that you are using .
There is a button .
This machine supports WPS
(Wi-Fi Protected Setup) .
You can easily setup if your
wireless router has a button,
and if the mark is on the
wireless router .
If you are not sure whether or not your wireless router supports
WPS, please see the manual included in the product, or contact the
product manufacturer .
There is no button .
If there is no button on your
wireless router, you may
manually select SSID and
complete the settings . In this
case, you need to specify SSID
and network key of your wireless
router .
See "Checking SSID or Network Key for a Wireless Router"
(P .7) to learn how to find out your SSID and network key .
To set up with WPS PIN code method, or setup
manually:
e-Manual "Connecting to a Wireless LAN"
• When proceeding from "Connecting the Power
Cord and Turning ON the Power" in the Getting
Started:
Proceed to step 4 of "Setting Wireless LAN" (P .5) .