Cleaning A Dry Cartridge Filter; Cleaning And Disinfecting The Ash Vacuum; Cord Maintenance & Storage; Ash Vacuum Storage - Craftsman CMXEVBE175850 Instruction Manual

Cleaning A Dry Cartridge Filter

NOTE: For best cleaning results due to accumulated dust,
clean the Filter in an open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from the Filter can
be accomplished without removing the Filter from the
Vacuum. Simply slap your hand on top of the handle
while the Vacuum is turned off.
2. Remove Filter from Vacuum. Gently tap the Filter against
the inside wall of your Drum, or against the floor, and the
debris will loosen and fall.
Cleaning and Disinfecting the
Ash Vacuum
To keep your Vacuum looking its best, clean the outside with
a cloth dampened with warm water and mild soap.
To clean the Drum:
1. Dump debris out.
2. Wash the Drum thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
Cord Maintenance & Storage
When vacuuming is complete, unplug the Power Cord and
wrap it around the Powerhead Handle. Accessories can be
stored on the rear of the Powerhead Assembly.
WARNING:
!
To prevent serious injury from electrical shock,
stop vacuum use immediately if the power cord is
damaged. Take the vacuum to a qualified service
dealer for inspection and possible repair.
SP7088-2 CMXEVBE175850.indb 15

Ash Vacuum Storage

Before storing your Vacuum, the Drum should be emptied
and cleaned. The Power Cord should be wrapped around the
Carry Handle. Positioning the Hose under the Carry Handle.
Accessories should be kept in the same area as the Vacuum
so they can be readily available. The Vacuum should be
stored indoors.
WARNING:
!
To assure product SAFETY and RELIABILITY, any other
maintenance, repairs and adjustments should be
performed by Authorized Service Centers, always
using CRAFTSMAN replacement parts.
15
10/24/19 11:59 AM