Veo Capture 1300 Getting Started page 38

Installing the Veo Capture 1300
Software
1. Insert the Veo Capture 1300 CD-ROM into the CD-ROM drive of
your computer.
2. The following installation screen
will appear. Click Install to begin the
software installation. If the following
screen does not appear, click on
Start->Run and type in:
D:\veoautorun.exe (D:\ refers to the
letter of your CD-ROM drive,
however, you may need to change the
drive letter if your CD-ROM drive is
located as another drive letter). Click
OK to start the installation screen.
3. Click OK to begin the software
installation. All the software will be
installed unless they are unchecked.
Note: The Veo Capture 1300 Camera
Drivers must be installed and cannot be unchecked.
38