Listening To The Radio - Venturer CD7106VI Instruction Manual

1. Press the STANDBY/ON button to turn the unit on.
2. Press the FUNCTION button to radio mode.
3. Press the BAND/ STOP button to select a band (AM/FM).
4. Press the or button to tune in to a station.
• Adjust the volume levels.
Searching for a Station Automatically
• Press and hold the
tuning in a station, the search stops.
• The search may not stop at a station with a very weak signal.
Presetting Stations
The unit can store a total of 20 stations in memory (10FM, 10AM). Presetting allows you to tune in to
a station directly.
1. Tune in to a desired station.
2. Press the PROG/MEM/
on the display.
3. Press the MEM.UP/
4. Press the PROG/MEM/
5. Repeat steps 1-4 to store other stations.
Tuning in to a Preset Station
Press the BAND/ STOP button to select AM or FM then press the MEM.UP/
number.
For Better Reception
FM: Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds best.
Note: Do not connect the FM antenna to an outside antenna.
AM: Reposition the unit to get better AM reception.
Notes:
• When the reception is good, the "STEREO" indicator will appear on the display.
• To prevent interference to the AM signal, please keep the AC adapter 3.17 feet (1 meter) away from the
main unit.
1. Press the STANDBY/ON button to turn on the unit.
2. Slide the OPEN knob to open the CD door. Place a disc in the center with the label side front and then
close the CD door gently.
3. Press the FUNCTION button to CD mode. "
track no. is shown on the display.
4. Press the PLAY/PAUSE button to start playing.
• Adjust the volume levels.
To Pause Playback
• Press the PLAY/PAUSE button.
• To resume playback, press the
To Stop Playback
• Press the BAND/ STOP button.

LISTENING TO THE RADIO

or button until the tuner starts searching for a station, then release. After
button. The preset number will blink and the "MEM" indicator will be shown
button to select the preset number.
button again to store it in memory.
CD PLAYBACK
" appears and "- -" blinks on the display. Then the total
PLAY/PAUSE button again.
- 7 -
button to select a preset