System Connections; Charge Your Smartphone/Tablet; Line In Connection; Clock Setting - Venturer CD6698BL Product Manual

SPeaKer connectionS
Connect the speakers to the R terminal and the L terminal.
note : Connecting speakers other than the speakers supplied with the unit may damage the unit.
cautionS:
• Ensure that the power supply in your house complies with that indicated on the identification sticker located
on the back of your unit. (AC 120V ~ 60Hz).
• If you are not going to use the unit for a long time, disconnect the AC power plug from the wall outlet.
• This unit is designed for continuous use. Switching off the unit to standby mode does not disconnect it
from the power supply. To completely isolate the equipment, remove the plug from the wall outlet as some
components remain connected to the electrical supply.
• To prevent electrical shock, match wide blade of plug to wide slot of wall outlet, then fully insert.
EN
You can charge your smartphone/tablet through the USB socket with a USB cable (not supplied).
Connect a USB cable (not supplied) to the USB socket on the front of the unit and the dock connector on your
smartphone/tablet.
You can connect audio devices such as your CD player or MP3 player to the unit via the LINE IN jack. To do this,
connect an audio cable from the line out or headphone out jack of the other audio device to the LINE IN jack on
the front of unit. Press the
note : We recommend you unplug the device from the LINE IN jack when not in use.
Setting the clock can only be done in STANDBY mode.
• If the unit is plugged in with the supplied AC adapter and the unit is in standby mode.
1. Press and hold the
2. Press the or
then the minute digits blink.
3. Press the or
clock.
Source button to switch to TUNER mode.
Press the
Searching for a Station automatically
• Press and hold the
a station, the search stops.
Presetting Stations
1. Tune in to a desired station. Press the
2. The preset number will blink and the "MEM" indicator will be shown on the display.
3. Press the or
/ProG/MeM button again to store it in memory.
4. Press the
tuning in to a Preset Station
Press the /MeM.uP button to select a preset number.
note : Fully unwind the wire antenna. Then extend the wire antenna and place it in the position that sounds best.
When the reception is good, the "
BWA17AA005_IB_r.indd 4

SySteM connectionS

cHarGe your SMartPHone/taBLet

Line in connection

Source button to switch to AUX mode.

cLocK SettinG

/ProG/MeM button until the hour digits blink.
button to adjust the desired hours and press the
button to adjust the desired minutes and press the

LiSteninG to tHe raDio

or button until the tuner starts searching for a station, then release. After tuning in
/ProG/MeM button.
button to select the preset number.
" icon will appear on the display.
/ProG/MeM button once to confirm,
/ProG/MeM button once to start
EN - 4
2017/1/17 14:42:09