4.4
Connecting the Device to the Electricity Supply
Check prior to initial operation that the voltage noted on the model label
corresponds to the mains voltage.
If this is not the case, do not connect the device and contact your dealer!
4.5
Changing the Doorhang
1. Remove the lower hinge pin.
2. Take off the door by moving it upwards.
3. Unscrew the upper hinge pin and mount it on the opposite side hinge.
4. Fit the door on the upper hinge pin and mount the lower hinge pin.
5. Check that the door closes properly and seals all round.
6. If the door handle is mount, fix the door handle of the opposide side
Changing the Decor Panel
4.6
The door panel can easily be mounted or changed. The dimensions of the panel
must be:
Hight
Width
Thicknes max.
1. Remove the door, see Changing the Doorhang.
2. Unscrew the door strip and then withdraw the panel by sliding it downwards.
3. Fit the new panel in place and slide it up as far as possible.
4. Fit the door strip back in place.
4.7
Mount the Door Handle
The device must be connected to a properly earthed socket in line
with the relevant valid country regulations.
724,0 mm
492,5 mm
3,2 mm
6