Table of Contents
Advertisement
Normal Wheel
24
8
1. Slide a Ø12 washer (3) onto the front axle.
2. Slide the bushing (4) (ring end first) onto the front axle.
3. Slide the front wheel (5) onto the front axle. And keep the front wheel (5)
match with the bushing.
4. Slide a Ø12 washer (3) onto the front axle.
5. Tighten a lock nut (24) to the end of the front axle with a spanner.
6. "Snap" the hubcap (8) to the wheel cover.
- Repeat the above procedure to assemble the other front wheel. -
GAP
Attach the Front Wheels
3
After assembling any wheel to the axles, please check the
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel
and the wheel can't run smoothly, the motor will be broken
easily! Then you need to decrease one or two washers to make
sure the wheel can run smoothly!
Front axle
3
4
5
13
Front Bottom View
Hide quick links:
Advertisement
Table of Contents
