KTM 50 SX Setup Instructions page 7

3.1 Raising the motorcycle with a lift stand
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Park the vehicle on a firm and level surface.
3.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Park the vehicle on a firm and level surface.
3.3 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
1 0 0 1
2 0 0 2
–
Raise the motorcycle at the frame underneath the engine.
Lift stand (78929955100)
Neither wheel is in contact with the ground.
–
Secure the motorcycle against falling over.
401942-01
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
in stand bracket on the left side of the vehicle.
Info
Remove the plug-in stand before riding.
402581-10
–
Remove screws
the handlebar and lay it to one side.
Info
Protect the motorcycle and its attachments against
damage by covering them.
Do not kink the cables and lines.
–
Remove screws
400564-10
1
1
. Take off the handlebar clamps. Remove
2
. Remove the handlebar support.
WORK 3
into the plug-
5