Meter Setup - Hanna Instruments HI99300 Instruction Manual

METER SETUP

Setup mode allows the selection of the Temperature unit,
Auto‑off, Beep confirmation tone, temperature compensation
factor for EC and TDS conversion factor. To enter Setup mode
press and hold
replaced by "SETUP" and
• "TEMP" is displayed on the
secondary LCD line with the current
temperature unit (e.g. "TEMP °C"),
for °C/°F selection, use the SET
button. After the temperature unit has
been selected, press
and to enter the "A-OFF" selection.
• Use the SET button, to navigate
through the auto‑off choices: 8
minutes ("8", default value), 60
minutes ("60") or disabled ("---").
Press
"BEEP" selection.
• To switch the beep tone ON or OFF,
press the SET button; press
confirm and to enter the EC
temperature compensation factor
selection "BETA".
• The meter will show the current
factor "1.9" on the primary LCD and
"BETA" on the secondary LCD.
Change the set factor with the SET
button. Press
enter TDS conversion factor "CONV".
• The meter will show the set
conversion factor "0.50" on the
primary LCD and "CONV" on the
secondary LCD. Change the set
conversion factor with the SET
button. Press
return to normal mode.
14
button until "STD" and
to confirm and to enter the
to confirm and to
to confirm and to
tag. Release the button.
to confirm
to
tag is