Chapter 3 : WaveRunner Windows 95 Installation
Before installing your WaveRunner ISDN/Analog Modem, be sure you have the
required items listed in Chapter 2: What You Will Need for a Successful
Installation. Now you are ready to install your WaveRunner ISDN/Analog
Modem.
Note: (PCMCIA only) Before you begin your installation, make sure your
WaveRunner adapter is removed from your system.
Installation Procedures
Follow these steps:
1.
If you have not done so already, uninstall previous versions of
WaveRunner software by following the directions in Chapter 2.
2.
If your WaveRunner software is not on your hard disk or network disk,
insert WaveRunner Installation Disk 1 or CD-ROM.
3.
In My Computer, open up the disk or folder where the WaveRunner
software resides (e.g., if you are installing from diskette, open 3 ½
floppy).
4.
Double-click Setup. The screen displayed in Figure 1 appears.
Note: SETUP may not run from a DOS shell or from RUN on some systems.
To ensure a successful installation, follow the steps above to run
SETUP.
Depending on the type of system you have, which Windows components are
already installed and which version of Windows 95 you are running, SETUP will
provide the appropriate on-line instructions.
10