Monitor - Bottom Cover - Qume QVT 101 Maintenance Manual

SUBASSEMBLY REMOVAL AND REPLACEMENT
Mon;tor - Botto. Cover
REMOVAL
To remove the bottom cover for access to the lower monitor area (Power/Logic
PCB, proceed as follows. See Figure 2-5.
CAUTION
Hazardous voltages are exposed in the general
area of the power supply. Before perfomi ng
any service in the lower monitor area, power
OFF the terminal and disconnect the power
cord.
1. Remove the knob from the brightness potentiometer.
2. Lay the moni tor on its side and loosen the four recessed screws at the
corners. These screws are captive screws, so it is not necessary to
remove them.
3. Remove the bottom cover from the monitor. To remove any of the
subassemb
1
i es mounted on the i nsi de of the bottom cover, refer to the
appropriate removal procedure.
REPLACEMENT
To replace bottom cover, perform removal instructions in reverse order.
2-9