Table of Contents
Advertisement
FACTORY DEFAULT SETTINGS
Setting
(P1) Auger Period
(P2) Cold Stove Temp
(P3) Hot Stove Temp
(P4) Hot Stove Hysterisis
(P5) Room Air On Temp
(P6) Auger Load Time
(P7) Igniter On Time
(P8) Start-Up Time
(P9) Factory Defaults
(PA) Room Fan On Temp
(PB) Auger Start Operation
(PC) Auger Operation Select
FACTORY DEFAULTS
Description
Time limit for the upper auger period of
operation. Display in is 1/10th sec.
Low temperature limit that a warm stove
must reach in order to shut down com-
pletely.
Maximum temperature limit that the stove
is allowed to reach before ceasing to feed
fuel.
Temperature differential below the Hot
Stove Temp that the stove must reach be-
fore resuming operation.
Minimum temperature that the stove must
reach before the room air fan will operate.
Time limit that the auger will feed fuel dur-
ing the start-up sequence prior to engag-
ing the automatic igniter.
Time limit that the automatic igniter is en-
gaged during the start-up sequence.
Time limit that the stove will be allowed to
operate before the Room Air On Temp
must be reached.
Selecting this variable will reset all of the
variables to the factory defaults.
High temperature limit that will cause the
stove to reduce the fuel feed rate by 25%
and maximize the room air fan speed.
Variable to control the auger fuel feed dur-
ing start-up. (0 = On, 1 = Off).
Variable to set the upper auger period of
operation. (0 = 4 sec, 1 = 6 sec)
-25-
Default
Value
16 sec
95 deg F
350 deg F
1 deg F
115 deg F
15 sec
8 min
15 min
-
290 deg
0
1
Hide quick links:
Advertisement
Table of Contents
