Front Panel - Fender Passport Event Series 2 Owner's Manual

A. MASTER VOLUME: Adjusts overall loudness. No sound is
produced at full counterclockwise position.
B. SIGNAL LEVEL METERS: Indicate left/right power amp output
signal level. If meters illuminate red, reduce MASTER VOLUME
(A) to prevent distortion and avoid amp overload/shutdown
(see item R, POWER/PROTECT LED, to reset unit after protect-
mode shutdown).
C. SIGNAL/CLIP LED: Illuminates green when signal is present;
yellow when signal level is -10dB away from clipping. Illuminates
red during clipping (see step 9 under SYSTEM SETUP).
D. CHANNEL VOLUME: Adjusts individual channel loudness.
E. TREBLE/BASS: Adjusts individual channel treble and bass tone,
with "flat" response at center-detented position.
F. REVERB: Adjusts individual channel reverb effect.
G. MIC/LINE SWITCH: If signal source level is too high (see step
9 under SYSTEM SETUP), press in to reduce input sensitivity by
24dB.
H. MONO CHANNEL INPUT: XLR and 1/4" input for microphones,
instruments and other mono line-level sources for channels 1
through 4.
I. LINE/INSTRUMENT SWITCH: For channel 5 only, switch
activates high-impedance ("Hi-Z") preamp for passive
instruments such as electric guitars and basses. For line-level
input or if clipping (distortion) occurs, disengage switch.
J. 1/4"-ONLY MONO CHANNEL INPUT: Same as MONO
CHANNEL INPUT (H) above, but 1/4" only (no XLR).
K. PAIR BLUETOOTH: Press for Bluetooth pairing with external
devices. When button is flashing blue, select "PASSPORT EVENT"
in external device Bluetooth menu. Button will stop flashing
and illuminate blue continuously when connection is successful.
Press and hold button to disconnect Bluetooth. For best sound
quality, set volume control on external device (i.e., smart phone)
to 75-100 percent of its maximum level.
L. 1/4" LEFT (MONO)/RIGHT INPUT: Inputs for line-level stereo
audio sources requiring separate 1/4" jacks for each channel.
Using stereo L/MONO jack by itself functions as mono channel;
mono output will be heard from both speakers.
M. 1/8" STEREO INPUT: Input for mobile devices, computers and
other line-level stereo audio sources with 1/8" connection.
N. HEADPHONE OUTPUT: Connect headphones and recording
equipment here. Individual channel controls affect this output;
MASTER VOLUME (A) does not.
O. LEVEL CONTROL: Adjusts HEADPHONE OUTPUT (N) and
MONO OUTPUT (P) signal levels.

FRONT PANEL

P. MONO OUTPUT: For connection to a powered monitor. Signal
level is pre-MASTER VOLUME (A); can be adjusted using LEVEL
CONTROL (O).
Q. SUB OUTPUT: For connection to a powered subwoofer. Set
subwoofer crossover frequency control to 120Hz. Use subwoofer's
volume or level control to set bass level to preference. External
subwoofer use automatically removes signals below 120Hz from
main Passport amp and speakers.
R. POWER/PROTECT LED: POWER LED illuminates green when system
is on. Passport features internal protection measures that will shut
down audio output in the event of electrical or thermal problems;
PROTECT LED will illuminate red when this happens. Passport will
automatically reset itself on resolution of such problems. If Passport
does not reset automatically, check fuse in power cord socket on
rear panel (O). If PROTECT LED remains illuminated after unit has had
sufficient cooling time and other power outlets have been tried,
consult an authorized Fender Service Center.
3