Getting Started; Base Installation - Uniden UBC9000XLT Operating Manual

Getting Started
Standard
h
240V
AC Wall Outlet
DC 13.8V
Jack
Auxiliary Antenna
Jack Jack
Telescoping
Antenna
AC Adaptor!
Charger
(AAD8500U)
J-
Plug
Off-On!
Enter-Lock
Switch
FoldingLeg
Base Installation
1. Insert the DC plug end of the AC Adaptor into the DC 13.8Vjack
on the rear panel.
2. Plug the AC Adaptor into a standard 240V AC wall outlet.
3. Plug the Telescoping Antenna into the "ANT'connector. Extend
the antenna to its full height. For frequencies higher than
406 MHz, shortening the antenna may improve the reception.
4. If you need a better viewing angle, flip the folding legs down to
raise the front of the scanner.
For use with
an optional external speaker:
Plug the external speaker into the "EXTSP' jack
located on the front of the scanner.
«:: PROG ~ ~ SEND ~ ~ ALPHA:}
~HOLD~
(.SRC J (AUTO.)
For use with an optional tape recorder:
Be sure to use a tape recorder with
microphone and remote input jacks.
'--
UMIT
~
UNE EXTSP
@ @
1. Connecta cablefromthe "LINE"jack on the
front of the scanner to the microphoneinput of a tape recorder.
2. Connect a cable from the RCA-type "AUX" jack on the back of
the scanner to the recorder's "REMOTE"jack.
(See "Using Auto Record," page 41.)
For use with an optional CTCSS Tone Board:
CTCSS Board Socket (inside the unit). See "CTCSS Operation,"page 45.
6