Chain Search Mode; Chain Search Hold Mode - Uniden UBC69XLT Owner's Manual

UB334 Paper OM reduced size.fm Page 29 Friday, September 9, 2005 11:16 AM
BAND PLAN 3
Bank Frequency (MHz)
No.
1 25.0000 - 29.9950
2 160.6000 - 162.5950
3 162.6000 - 173.9950
4 440.0000 - 465.99375
5 466.0000 - 469.99375
See page 8 for how to switch the band between 1, 2
and 3.

Chain Search Mode

Press Func + Src to start chain search mode. SRCH,
the enabled search bank number, and
(indicating the search direction) appear. The search
bank number being searched flashes.
Press 1-5 to enable or disable the search bank
number being searched in this mode. Enabled bank
numbers appear. (Disabled bank numbers
disappear).
At least one search bank must be enabled. (The
scanner sounds an error tone if you try to disable all
the search banks). The search bank and the
frequency where chain search starts depends on
how the scanner was set before you selected chain
search mode.

Chain Search Hold Mode

To start chain search hold mode, press Hold in
chain search mode. The scanner stops searching
and Hold appears. In this mode, pressing
Func + changes the search direction downward
and pressing Func +
Step (kHz)
5
5
5
6.25
6.25
or
changes the search
Special Features
29