Responding To Error Messages - Canon WFT-E9 Advanced User's Manual

Responding to Error Messages

If transmitter errors are displayed on the camera's LCD monitor, refer to the examples of
corrective actions in this section to eliminate the cause of the error. When an error has
occurred, the <
on the LCD panel. The error details can also be checked in the menu [
settings]→[Error description].
Click the error code number in the following table to jump to the corresponding page.
11 12
21 22
41 43
61 63
71 72
82 83
91
11: Connection target not found
If you are using [EOS Utility], is EOS Utility running?
• Start EOS Utility and re-establish the connection (
Are the transmitter and the access point set to use the same encryption key for
authentication?
• This error occurs if the encryption keys do not match when the authentication
method for encryption is set to [Open system].
The encryption key is case-sensitive. Make sure to enter the correct encryption key
for authentication on the transmitter by verifying the uppercase and lowercase
letters used in it (
12: Connection target not found
Are the target device and access point turned on?
• Turn on the target device and the access point, then wait a while. If a connection still
cannot be established, perform the procedures to establish the connection again.
21: No address assigned by DHCP server
What to check on the transmitter
On the transmitter, the IP address is set to [Auto setting]. Is this the correct
setting?
• If no DHCP server is used, configure settings after setting the IP addresses to
[Manual setting] on the transmitter (
> lamp on the transmitter blinks and the error code number is shown
23
44 45
64 65
73
).
46 47
66 67
).
).
178
: Network
48
68 69