Installing The Belt Clip; Installing The Optional Headset - Uniden WDSS 5305 Owner's Manual

Installing the Belt Clip
Lne up the tabs wth the holes on each sde of
the handset. Press the belt clp down untl both
tabs clck nto place.
To remove the belt clp, pull both sdes of the clp
to release the tabs from the holes.
Installing the Optional Headset
Your phone may be used wth an optonal headset.
To use a headset, nsert the headset plug nto the
headset jack. Headsets may be purchased by
callng the Unden Parts Department. See back
cover page for contact nformaton.
Charging the Accessory Handset
The handset s powered by a rechargeable battery pack that
automatcally recharges when the handset s placed n the
charger.
) Connect the AC adapter to the DC IN 9V jack and to a 40V
AC outlet that s not controlled by a wall swtch.
Caution: Use only the Uniden AAD-600S adapter.
) Set the charger on a
desk or tabletop, and
place the handset n the
charger wth the keypad
facng forward.
3) Make sure that the
charge LED llumnates.
If the LED does not
llumnate, check to see
that the AC adapter
s plugged n and
the handset makes
good contact wth the
chargng contacts on
the chargng cradle.
4) Charge the handset battery pack for at least 5-0 hours
before using your new handset for the first time.
Route the Route the
cord. cord.
To AC outlet To AC outlet To DC IN 9V To DC IN 9V
AC adapter (supplied) AC adapter (supplied)
3