Table of Contents
Advertisement
6.7.10
Sending a Silent Emergency Alarm
When and where to use: This feature allows you to send an Emergency Alarm to the system without
triggering any audio or visual indicators.
Procedure:
1 Press the preprogrammed Emergency button.
The display shows no changes, the LED does not light up, and you hear no tones. The silent
emergency state continues until you perform the next step.
2 Perform one of the following actions:
•
Press and hold the preprogrammed Emergency button for about a second to exit the Silent
Emergency Alarm mode.
•
Press and release the PTT button to exit the Silent Emergency Alarm mode and enter regular
dispatch or Emergency Call mode.
6.7.11
Emergency Find Me
When the radio is in Emergency mode, the Emergency Find Me feature transmits Bluetooth Low
Energy (BTLE) signals and other Emergency information to nearby radios.
Contact your system administrator for more information.
6.7.11.1
Sending and Receiving Emergency Find Me Beacon
Procedure:
1 Press the pre-programmed Emergency button to transmit the EFM beacon.
The receiving radio displays Beacon RX and the transmitting radio Contact ID or alias on the
radio display. In the case of multiple radios transmitting at one time, the receiving radio displays
Multiple Beacon RX.
2 Press the menu Bcon. The receiving radio displays the transmitting radios Contact ID and one
of the following RSSI values based on the signal strength received:
•
RSSI-Excellent
•
RSSI-Good
•
RSSI-Fair
•
RSSI-Poor
NOTICE: RSSI-Poor will be shown if the distance between transmit radio and receive
radios are more than 8 to 10 meters in an open environment.
6.8
Fireground
The portable Fireground Communications System is designed for deployment at an incident scene.
MN004476A01-AE
Chapter 6: Advanced Features
69
Advertisement
Table of Contents
