Introduction - Husqvarna 570 XP/G Workshop Manual

General
This Workshop Manual provides a comprehensive
description of how to trouble shoot, repair and test the
chainsaw. A description of different safety measures that
should be taken during repair work is also given.
Safety
Note!.The.section.dealing.with.safety.should.be.read.
and.understood.by.all.who.carry.out..repair.and.service.
work.on.the.chainsaw.
Warning symbols can be found in this Workshop Manual
and on the chainsaw. See page 5. A new warning symbol
must be applied as soon as possible if a warning symbol on
the chainsaw has been damaged or is missing to ensure
the greatest possible safety when using the chainsaw.
Target.Group
When producing this Workshop Manual the assumption
has been made that personnel who use it have general
knowledge in the repair and service of small engines.
The Workshop Manual must be read and understood by
personnel who are to carry out repair work and service on
the chainsaw. The Manual is also suitable for use when
training new employees.
Modifications
Modifications will be successively introduced on the
chainsaw during production. When these modifications
affect servicing and/or spare parts, separate service
information will be sent out on each occasion. This means
that in time this Workshop manual will become out of
date. In order to prevent this, the Manual should be read
together with all service information issued concerning
the chainsaw in question.
Tools
Special tools must be used during specific steps. All service
tools are listed in the Workshop Manual. Usage is evident
from respective sections.
Always.use.Husqvarna.original.parts:
• Spare parts
• Service tools
• Accessories

INTRODUCTION

Layout
This Workshop Manual can be used in two different ways:
• For the repair of a particular system on the
chainsaw.
• Dismantling and Assembly of the entire chainsaw.
Repair.of.a.particular.system
When a particular system on the chainsaw is to be repaired,
proceed as follows:
1. Look up the page for the system in question.
2. Carry out the sections: Dismantling
Dismantling.and.Assembly.of.the.entire.chainsaw
Proceed as follows when the entire chainsaw is to be
dismantled and assembled:
1. Look up page 18, which deals with the Starter.and
carry out the instructions under the heading . .
. Dismantling.
2. Leaf forward in the book and carry out Dismantling..
in the order given in the sections.
.
3. Go back to Starter.on page 18 and carry out the
instructions under Cleaning.and.inspection.
4. Leaf forward in the book and carry out Cleaning..
and.inspection in the order given in the sections.
.
5. Order or take out all requisite spare parts from the
stores.
6. Look up page 51 which deals with the Crankcase..
and carry out the instructions under Assembly.
.
7. Leaf forward in the book and carry out Assembly..
in the order given in the sections.
.
To improve understanding some sections provide a
Description.first of the actual unit.
Numbering
Position references to components inside the figures are
designated A, and B, etc.
The figures are number 1, 2 etc.
The position references figure numbers restart in each
new section.
Cleaning and inspection
Assembly
English – 3