Lenovo ThinkSystem SR645 Setup Manual page 132

Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID. For more information, see:
https://sysmgt.lenovofiles.com/help/topic/LXPMv3/LXPMv3_introduction.html
Adjust the retainer on the M.2 adapter
Use this information to adjust the retainer on the M.2 adapter.
About this task
Attention:
• Read "Installation guidelines" on page 92 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DY1RaWHYM4xDloAwuBQHR0
• Youku:
http://list.youku.com/albumlist/show/id_52339628
Procedure
Note: The M.2 adapter you want to adjust might be different from the following illustrations, but the
adjustment method is the same.
Figure 51. M.2 retainer adjustment
Step 1. Press both sides of the retainers.
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole into which the retainer should be installed to
accommodate the particular size of the M.2 drive you wish to install.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.
ThinkSystem SR645 Setup Guide
128