Table of Contents
Advertisement
Installing Memory Modules
This mainboard accommodates two 184-pin 2.5V unbuffered Double Data
Rate (DDR) SDRAM memory modules.
Installation Procedure
You must install at least one module
in any of the two slots. Each module
can be installed with 64 MB to 512
MB of memory. Total capacity is
2GB.
Refer to the following to install the memory modules.
1.
Push the latches on each side of the DIMM slot down.
2.
Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
3.
Check that the cutouts on the
DIMM module edge connec-
tor match the notches in the
DIMM slot:
4.
Install the DIMM module into
the slot and press it firmly
down until it seats correctly.
The slot latches are levered
upwards and latch on to the
edges of the DIMM.
5.
Install any remaining DIMM
modules.
Latch
Cutout
Notch
Latch
14
Advertisement
Table of Contents
