Maintenance - U-Line Combo CO29 Use And Care Manual

• Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transmit
taste to the interior products and damage or
discolor the interior.

Maintenance

Proper maintenance of your U-Line product will ensure
efficiency, top performance and long life. The
maintenance intervals listed are based on normal
conditions. You may want to shorten the intervals if you
have pets or other special considerations.
Defrosting
Manual Defrost Models - Every Two Months
(Minimum)
WARNING
DO NOT use any type of electrical heating device,
ice pick, knife or other sharp instrument to
defrost; this could damage the inner lining or
refrigeration system and void the warranty.
Figure 7
10
1
ULIN_0224_A
CO29, CO75
To defrost:
1. Turn unit off.
2. Remove all products from the interior.
3. Remove ice bucket and discard ice.
4. Place a towel or other absorbent material on bottom of
ice bin and bottom of unit (Figure 7, 1).
5. You can speed up the defrost process by filling the ice
bucket with warm water, not hot, and place the bucket
back into ice maker housing on the towel or other
absorbent material and close door to unit. Or prop door
open 2" (5 cm) minimum.
6. After approximately 1 hour, remove ice bucket and
discard water.
7. Allow the frost to completely melt naturally. Clean the
interior and ice bucket using a mild non-abrasive
detergent and warm water solution applied with a soft
sponge or non-abrasive cloth. NOTE: DO NOT use any
solvent-based or abrasive cleaners. They will discolor or
damage the interior.
8. Dampen a soft sponge or non-abrasive cloth in clean
water and wipe the cabinet interior and ice bucket to
remove any detergent residue. Rinse the sponge or
cloth in clean water and repeat as necessary until the
cabinet and ice bucket are clean, then dry interior with
a clean dry cloth.
IMPORTANT IMPORTANT
DO NOT place ice bucket in dishwasher. The heat in a
dishwasher will warp, discolor and damage the ice
bucket.
9. When interior is dry, turn unit back on.
NOTE: To safeguard against contaminants in ice, discard
first three batches of ice after defrosting.