5. On a clean surface, place the wood panel face down and tape the
existing drawer panel (removed in step 3) on the back of the wood
panel (Figure 10) and drill the five (5) holes (5/32" drill 3/8" deep)
through the coated steel panel and 3/8" into the wood panel
according to the diagram (Figure 11). Remove tape from the draw-
er panel, and enlarge the five holes in the front panel using a .0201"
drill (#7) drill.
NOTE:
For 1/2" gap between
top and bottom panels,
this dimension must be
11/32". For 1/4" gap, this
dimension must be 19/32"
for TOP PANEL ONLY.
TOP OF WOOD PANEL
2-15/16"
A
SIDE OF
BACK OF
WOOD PANEL
WOOD PANEL
Figure 10
5/32" X 3/8" DEEP
5 PLACES
C
1"
11-7/8"
Figure 11
COATED STEEL
DRAWER PANEL
TAPE
3/8" BOTH SIDES
23-3/4"
13
BOTTOM OF
WOOD PANEL
DWR_OL_003
COATED STEEL
DRAWER PANEL
B
1"
DWR_OL_004