Accessories; Introduction - Marco C 36 HC Installing & Operating Manual

ACCESSORIES
IEPLACE GRATE:
is unit has been equipped with a grate designed to keep
!
operation of your fireplace efficient and safe.
See
Page
for operating instructions.
.ASS DOORS:
fold glass doors can be installed as an optional ac-
ssory. Use MARCO door kit #793411 and refer to the
itallation instructions in that kit for installation details.
e glass doors can be installed before, during or after
?
installation of the fireplace. NOTE: Use of glass
~ors other than those manufactured by Marco Mfg.,
: .
could create a potentially hazardous condition
d will void the MARCO warranty.
UTSIDE AIR:
1
optional outside air kit is available for installation.
'93250 outside air kit, if desired, must be installed
/ring
the installation of the fireplace (see Page 6).
\N KIT
fan kit #(793616) is also available as an optional
:cessory. The fan kit can be installed prior to or after
stallation of the fireplace. NOTE: This model fire-
ace does not require a wall switch in order for the
ns to operate. Refer to the #P/N 181624 Fan Kit
stallation Instructions for installation details. THE
REPLACE MUST BE WIREDTO THE HOUSE ELEC-
3ICAL SYSTEM AT THE TIME OF INSTALLATION IN
RDER FOR THE CfPTIONAL FANS TO OPERATE
;ee Figure 1 & 1A)
OTE: The utilization of fans will increase the air flow
round the firebox. However, only a minimal increase in
eat output should be anticipated.
'OWER TO THE FIREPLACE
'93616 Fan Kit operates on
15 volt 60 Hz 40 wafts AC.
OUSE WIRING
COVER PLATE
Replace cover plate after
electrical hook-up.
House wiring must
be
secured
GROUNO WIRE
with the appropriate electrical
connector to the fireplace
FIGURE
1
--
convenience outlet wiring.
I
If. INSTALLATION
INSTRUCTIONS
INTRODUCTION
Before beginning the installation of your fireplace, read
through these instructions and the instructions contain-
ed in the separate Operation Manual.
This MARCO fireplace and components are safe when
installed according to this Installation Manual. Unless
you use MARCO components which have been design-
ed and tested for the fireplace system, you may cause
a fire hazard.
. .
MARCO Classic 36" fireplaces may be installed in a
conventional home or a prefabricated home.
The MARCO warranty will be voided by, and MARCO
disclaims any responsibility for, the following actions:
a) Modifications of the fireplace andlor components, in-
cluding assembly of chimney, glass doors, air inlet
system and damper control.
.
b ) Use of any component part not manufactured or ap-
proved by MARCO in combination with a MARCO
fireplace system.
c ) Installation other than as instructed in this manual.
d) Do not use a fireplace insert or other products not
specified for use with these fireplaces.
PROPER INSTALLATION is the most important step in
ensuring safe, long-term operation of this fireplace. Con-
sult the local building codes as to the particular re-
quirements concerning installation of all factory-built
fireplaces. Although grounding may not be required by
code, it is recommended by the manufacturer.
This fireplace is not intended to be used as a
substitute for a furnace to heat an entire home.
Use for supplementary heating only.