Figure 7.6 Bridge Non-Ip - Tut Systems XL-12000S User Manual

The static routing table fields in the Modem 1 Configuration would be:
Destination
192.168.4.0
For Modem 2:
The "LAN IP address" field in the Modem Configuration screen will
be set to 192.168.4.1
The LAN "Subnet Mask" field in the Modem Configuration screen
will be set to 255.255.255.0
The "DSL IP address" field in the Modem Configuration screen will
be set to 192.168.3.2
The DSL "Subnet Mask" field in the Modem Configuration screen
will be set to 255.255.255.0
The "Master/Slave" field in the Modem Configuration screen will be
set to Slave.
The "Routing/Bridging" field in the Modem Configuration screen
will be set to ip_routing_only
The static routing table fields in the Modem 2 Configuration would
be:
Destination
192.168.2.0
3. Bridge Non-IP
This selection will enable the modem to route IP traffic and bridge
non-IP traffic at the same time. The modem passes only IP packets
between networks attached to the LAN and DSL sides of the modem
and networks designated in the modems static routing tables.
Bridge non-IP example: This example shows how the XL-12000S
routes IP packets. However, the Macintosh can still use the Apple
printer located in another building because non-IP packets
(AppleTalk) are bridged across the DSL line.
7.0 CONFIGURE THE MODEM
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
Mask
255.255.255.0
Mask
255.255.255.0
XL-12000S
Gateway
192.168.3.2
Gateway
192.168.3.1
TUT SYSTEMS
Hops
1
Hops
1
23