List Of 140Rx-Fi Usage Conditions; Installation Procedure - O.S. engine MAX 140RX FI Owner's Instruction Manual

List of 140RX-FI Usage Conditions

Part Manufacturer
Exhaust manifold
O.S.
Tuned silencer
Glow plug
Commercially
Propeller
available
high-quality
product
Commercially
Fuel
available
high-quality
product
Transmitter
Aircraft
The contents of the user's manual are based on those products indicated with an asterisk (*).

Installation Procedure

Install the 140RX FI while taking the following matters into consideration.
(1) MAX-140RX FI Engine
The following components are required during installation: EC-1, y harness, check valve, fuel
filter, manifold (sold separately), T-6010 silencer (sold separately), extension cord (sold
separately), double-sided, sponge-backed cushioning tape.
(2) Engine Mount
A soft engine mount is recommended but should be made of firm enough material to prevent
excessive engine movement but still minimize engine vibration. If engine vibration is excessive
the opening angle of the air valve may vary causing unstable engine operation and possible
stalling. In addition, adequate clearance must be provided to ensure there is no contact
between the injector, temperature sensor and rotation sensor with the airframe.
*For the 140RX
O.S.
*T-6010
O.S.
*Type F
General references:
*16x14(2 blades)
15x12(4 blades)
15x13.5(3 blades)
15x14(3 blades)
10-25% nitromethane
15-20% oil
FUTABA
*1024ZA
FUTABA
FF8A
PCM10S
JR
PCM10X
JR
X3810
JR
SANWA
STYLUS
Name
Adjustment may vary slightly
according to the amounts of
nitromethane and oil.
Spare channel dial (used at
100% by canceling mixing
and expo, etc. when used
alone.
Only Z connectors can be
used (check whether polarity
matches).
For 2m class F3A
10
Remarks
Mid-range engine speed
should be approximately
6,500 rpm.
Maximun speed should be
between 7,300 and 8,000
rpm.