Handling Your Appliance; Positioniing Your Appliance - Husky HUS-ZY Series Instruction Manual

HUSKY INSTRUCTION MANUAL

HANDLING YOUR APPLIANCE

This appliance uses R600a (Isobutane) natural refrigerant gas as part of its cooling system.
R600a is environmentally friendly but can be combustible. Care should therefore be taken
when handling or transporting the product to ensure that none of the refrigeration circuit
components are damaged.
To lift the appliance safely, tilt it backwards by no more than 45 degrees, hold the base and
rear corners of the appliance carefully. Never use the door handles for lifting.
This appliance is heavy and could cause injury. Ensure there are adequate people present to
move the appliance.
POSITIONING YOUR APPLIANCE
• With the exception of the models listed below, please allow a minimum of 50mm
clearance at the rear of the wine cooler and sufficient room around the sides and top
of the wine cooler to enable good air circulation. Clearance dimensions for specific
models are listed below:
Model
HUS-WC54S
HUS-DC54
HUS-WC54D
HUS-WC66B
• Ensure that the appliance is situated:
• Away from direct sunlight and in a dry and well-ventilated space
• Away from stoves, ovens, radiators and any other heating appliances
• Do not position the appliance in conservatories or outbuildings with extreme high or
low ambient temperatures
• Do not use outdoors or leave in rain
• Do not place anything on your appliance
• The appliance must be used in the vertical position and stand on an even, flat surface
for quieter operation
• If your appliance is to be to be placed on carpet, support it with a wooden board
underneath. Be aware that placing the appliance on carpet may mean that heat from
the compressor may cause the carpet to fade
• Ensure that the plug is easily accessible.
WARNING: When positioning the appliance ensure the supply cord is not
trapped or damaged. Do not locate extension sockets or charging transformers/
power supplies adjacent to the compressor at the back of the unit, as they could
overheat.
ZY all models manual 051118.indd 5
Dimensions
HxWxD (mm) (when built into cabinetry)
845x595x600
845x595x600
845x595x600
875x750x600
Clearances Dimensions
900x615x642
900x615x642
900x615x642
895x770x650
5
08/11/2018 16:39