Operating The Ez-Link System; Removing The Cutting Attachment Or Add-On; Installing The Cutting Attachment Or Add-On; Operating Instructions - Troy-Bilt TB90BC Operator's Manual

OPERATING THE EZ-LINK
The EZ-Link™ system enables the use of these optional
Add-Ons:
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBAH
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB
Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBPS
Brushcutter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TBBC*
*Do NOT use this attachment with an electric
powered product
WARNING:
and understand that attachment's specific
manual before you begin operation. Follow all
applicable safety information.

Removing the Cutting Attachment or Add-On

1. Turn the knob counterclockwise to loosen (Fig. 19).
2. Press and hold the release button (Fig. 19).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link™ coupler (Fig. 20).
WARNING:
damage to the unit, shut the unit off before
removing or installing add-ons.

Installing the Cutting Attachment or Add-On

NOTE: Place the unit on the ground or on a work bench
to make add-on installation or removal easier.
1. Turn knob counterclockwise to loosen (Fig. 19).
EZ-Link™ Coupler
Knob

OPERATING INSTRUCTIONS

™
SYSTEM
When using any
attachment, read
To avoid serious
personal injury and
Release Button
Guide Recess
Fig. 19
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler (Fig. 20).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 19).
EZ-Link™ Coupler
Upper Shaft Housing
3. Turn the knob clockwise to tighten (Fig. 21).
CAUTION:
hole and securely tighten the knob before
operating this unit.
90˚ Edging Hole
(Trimmer Only)
CAUTION:
hole only. Using the wrong hole could lead to
personal injury or damage to the unit.
For edging (when using the line head cutting attachment
with EZ-Link™ models), lock the release button of the
cutting attachment into the 90° edging hole (Fig. 21).
Release Button
Primary Hole
Lower Shaft Housing
Fig. 20
Lock the release
button in the primary
Knob
Fig. 21
Add-ons are to be
used in the primary
13