Advertisement
Expansion anchors: 4 pcs
Used to install the housing to the mounting surface.
Supported cameras
The housing can be used with the following box
cameras:
IP Box Camera
TVC-5401, TVC-5402, TVC-5403
Installation
To attach a box camera to the box camera
outdoor housing (TVC-OH3-HT):
1.
Loosen the two latches located on the side of
the TVC-OH3-HT to release the housing cover.
Lift the housing cover open.
2.
Loosen the four camera base plate screws and
remove the base plate from the camera
housing. Attach the box camera to the base
plate, using the two A screws.
2 / 4
Note: The appropriate lens must be installed
on the box camera before this step. Choose a
lens with specifications suitable for the
application.
3.
Install the camera and base plate assembly in
the housing. Tighten the four screws to keep
the camera assembly firmly in place.
4.
Connect the power supply cable (purchased
separately) to the 12 VDC input terminals on
the terminal panel.
RS485 output
1.
Yellow R485-
2.
Orange R485+
P/N 1073586-EN • REV A • ISS 29JAN19
DC 12 V output
3.
Black DC 12 V-
4.
Red DC 12 V+
Advertisement
