Troy-Bilt 569 Operator's Manual

21-inch self-propelled mulching mower
Hide thumbs Also See for 569:

Advertisement

Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty
OPERATOR'S MANUAL
21-inch Self-Propelled Mulching Mower — Model 569
IMPORTANT
READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law
(Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester
for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland,
Ohio 44136-0019.
FORM NO. 769-02344
PRINTED IN U.S.A
TROYBILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
1/23/2006

Advertisement

Table of Contents
loading

Summary of Contents for Troy-Bilt 569

  • Page 1 Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty OPERATOR’S MANUAL 21-inch Self-Propelled Mulching Mower — Model 569 IMPORTANT READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush- covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
  • Page 2: Table Of Contents

    Off-Season Storage and Safety Labels ... 13 Parts List ... 14 Warranty ... Back Cover Model Number www.troybilt.com Customer Support contacting Customer Support. Serial Number TROY-BILT LLC P. O. BOX 3 6 1 1 3 1 CLEVELAND, OH 44136 330-558-7220 866-840-6483...
  • Page 3: Slope Gauge

    Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes. Slope Gauge WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet).
  • Page 4: Safe Operation Practices

    DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can Safe result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.
  • Page 5: Slope Operation

    The cutting blade continues to rotate for a few seconds after the engine is shut off. Never place any part of the body in the blade area until you are sure the blade has stopped rotating. 20. Never operate mower without proper trailshield, discharge cover, grass catcher, blade control handle, or other safety protective devices in place and working.
  • Page 6: Setup And Adjustment

    Setup and Adjustment NOTE: Stand behind the mower as if you were going to operate it. Your right hand cor- responds to the right side of the mower; your left hand corresponds to the left side of the mower. IMPORTANT DO NOT crimp the cables when lifting the handle up.
  • Page 7: Drive Control

    5. Follow steps below to attach grass catcher: a. Lift rear discharge door. b. Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass catcher, Step 5. WARNING: Never operate mower unless the hooks on the grass catcher are firmly seated on the pivot rod and the rear discharge door rests firmly against top of the grass catcher.
  • Page 8: Operating Your Lawn Mower

    Operating Your Lawn Mower WARNING The blade control is a safety device. Never attempt to bypass its operations. Now that you have set up your lawn mower, it’s important to become acquainted with its controls and features. Use extreme care when handling Blade Control gasoline.
  • Page 9: Starting Engine

    Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower.
  • Page 10: Maintaining Your Lawn Mower

    Maintaining Your Lawn Mower WARNING Always stop engine, disconnect spark plug, and ground against engine before cleaning, lubricating or doing any kind of maintenance on your machine. General Recommendations • Always observe safety rules when performing any type of maintenance. •...
  • Page 11: Blade Care

    Blade Care WARNING: When removing cutting blade for sharpening or replacement, protect your hands with a pair of heavy gloves or use a heavy rag to hold blade. 1. Disconnect spark plug wire from spark plug. Turn mower on its side making sure that the air filter and the carburetor are up.
  • Page 12: Troubleshooting

    Problem Engine fails to start Trouble Shooting Engine runs erratic For repairs beyond the minor adjustments listed here, contact Engine overheats an authorized service dealer. Occasional skips (hesitates) at high speed Idles poorly Excessive Vibration Mower will not mulch grass (If Equipped) Uneven cut Mower will not...
  • Page 13: Off-Season Storage And Safety Labels

    Off-Season Storage The following steps should be taken to prepare your lawn mower for storage. 1. Clean and lubricate mower thoroughly as described in the lubrication instructions. 2. We do not recommend the use of a pressure washer or garden hose to clean your unit. 3.
  • Page 14 �� �� � � �� �� �� � �� �� � �� �� �� � �� � � �� �� �� �� � �� � �� � � �� � �� �� �� �� �� �� �� �� �� �� ��...
  • Page 15: Parts List

    Ref. Part No. Description 687-02193 Height Adj. Assembly - LH 687-02194 Height Adj. Assembly - RH 750-04405 Sleeve Spacer 1.8” Long 618-04377 Transmission 750-04404 Sleeve Spacer 9.10” Long 782-5002B Front Baffle 712-04065 Flange Lock Nut, 3/8-16 732-0708 Bearing Retainer 741-0604A Sleeve Bearing 748-0355 Bearing Support...
  • Page 17 Ref. Part No. Description 746-04206A Variable Speed Cable 731-04150C Rear Baffle 21” Rd. 710-04371 Screw 1/4-15 731-04204 Deluxe Bail Cover 747-1161A Blade Control 749-04206 Upper Handle 787-01258A Cable Mount Bracket 753-05096A Control Lever Assembly 720-0279 Handle Knob 720-04072 Star Knob 710-1205 Eye Bolt 746-0957...
  • Page 18 NOTES...
  • Page 19 NOTES...
  • Page 20 MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its posses- sions and territories. “Troy-Bilt” warrants this product against defects in material and workman-...

Table of Contents