Operating Instructions - Troy-Bilt 769-00485A P/N 769-00485A Operator's Manual

ASSEMBLING THE COUPLER
The following Troy-Bilt Add-Ons are also available for your unit:
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBAH
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB
Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBPS
WARNING:
the operator's manual for unit to be used with
this add-on.
Removing the add-on:
1. Turn the knob counterclockwise to loosen (Fig. 1).
2. Press and hold the release button (Fig. 1).
3. While firmly holding the upper shaft housing, pull the
garden cultivator Add-On out of the coupler (Fig. 2).
WARNING:
damage to the unit, shut the unit off before
removing or installing add-ons.
Installing the add-on:
NOTE: To make installing or removing the Add-On easier,
place the unit on the ground or on a work bench.
1. Remove the hanger from the top of the shaft housing.
2. Turn knob counterclockwise to loosen (Fig. 1).
3. While firmly holding the add-on, push it straight into
the coupler (Fig. 2).
Coupler
Release Button
Counterclockwise

OPERATING INSTRUCTIONS

Prior to operation,
read and understand
To avoid serious
personal injury and
Guide Recess
Clockwise
Knob
Fig. 1
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 1).
Coupler
Primary Hole
Upper Shaft
Knob
Housing
4. Turn the knob clockwise to tighten (Fig. 3).
CAUTION:
hole (Fig. 2) and securely tighten the knob
before operating this unit.
CAUTION:
be used in the primary hole only. Using the
wrong hole could lead to personal injury or
damage to the unit.
The cultivator add-on should be installed with the release
button in the primary hole.
Check Flex Shaft Engagement Prior to Using
1. Start the unit.
2. Briefly engage and release the trigger.
3. Check that add-on is operating.
4. If the add-on is not operating, remove add-on and
repeat steps for installing the add-on.
5. Recheck operation of add-on attachment.
Release Button
Lower Shaft
Housing
Fig. 2
Lock the release
button in the primary
Knob
Fig. 3
The add-ons with the
coupler system is to
7