Table of Contents
Advertisement
UNPACKING
Carefully unpack and remove the scroll saw and its
components from the box and check for damaged
or missing items as per the list of contents below.
NOTE: Please report any damaged or missing items to
your General International distributor immediately.
LIST OF CONTENTS
A - SCROLL SAW..............................................................1
B - POWER CORD ...........................................................1
C - HEX NUT .....................................................................8
D - LEVELING FOOT .........................................................4
E - 3 MM ALLEN KEY.......................................................1
F - BLADE.........................................................................1
NOTE: Unscrew the 4 shipping bolts and remove the saw
from the protective plywood shipping base.
INSTALLATION & ASSEMBLY
For your convenience this scroll saw is shipped from the factory partially assembled and requires only minimal
assembly and set-up before being put into service.
ATTACHING THE POWER CORD
Plug the female end of the power cord into the socket
at the rear of the saw as shown.
BEFORE STARTING THE ASSEMBLY, MAKE SURE
THAT THE SWITCH IS IN THE "OFF" POSITION
AND THAT THE POWER CORD IS UNPLUGGED.
DO NOT PLUG IN OR TURN ON THE SCROLL
SAW UNTIL YOU HAVE COMPLETED THE ASSEM-
BLY AND INSTALLATION STEPS DESCRIBED IN
THIS SECTION OF THE MANUAL.
INSTALL THE SAW ON A STABLE SURFACE
The unit should be installed on a flat, sturdy and stable
surface able to support the weight of the machine and
the workpiece with ease.
A
QTY
C
D
Never install the machine over the edge of a table or
workbench.
B
E
F
9
Advertisement
Table of Contents
